Allied Telesis AT-S70 - Manual (Page 22)

Chapter 2: Starting a Local or Telnet Management Session
22
Note
The Converteon™ chassis has an auto-detect feature on the serial
port that automatically determines the speed of the local terminal.
You activate this feature by pressing the Return or Enter key twice
on your keyboard when you initially start the local interface or within
five seconds after powering on or resetting the chassis. The chassis
determines the speed of the terminal and automatically configures
the speed of the “console” port accordingly. The chassis uses a data
rate of 11520000 bits per second (bps). The chassis maintains the
terminal port speed until the system is again powered ON or reset.
Note
The default settings for the terminal interface are for a DEC VT100
or ANSI terminal, or an equivalent terminal emulator program. Once
you have started an management session, you can change some of
these values.
4. Press key twice.
5. When prompted, enter a username and password.
ˆ To configure the chassis settings, enter “manager” as the
username. The default password for manager access is “friend”.
ˆ To just view the settings, enter “operator” as the username. The
default password for operator access is “operator”.
ˆ Usernames and passwords are case-sensitive.
ˆ For information on these two access levels, refer to “Management
Access Levels” on page 31.
For instructions on how to change a password, refer to “Manager and
Operator Passwords” on page 28.
After logging on, the Main Menu, shown in Figure 2, is displayed.
Figure 2. Main Menu
Allied Telesyn AT-CV5M01 Management Module Software V1.2.0
CV-5000 Chassis
Main Menu
Module Status and Configuration
Administration
System Configuration
Remote Module Status and Configuration
Quit