Allied Telesis AT-S70 - Manual (Page 31)

AT-S70 Management Software User’s Guide
31
Management Access Levels
There are two levels of management access in the AT-S70 management
software: Manager and Operator. When you log in as a Manager, you can
view and configure all operating parameters. When you log in as an
Operator, you can only view the operating parameters; you cannot change
any values.
You log in as a manager or an operator when you enter the appropriate
username and password when you start an AT-S70 management session.
To log in as a manager, type “manager” as the login name. The default
password is “friend”. The username for operator is “operator” and the
default password is also “operator”. The usernames and passwords are
case sensitive.
Note
Once the password has been changed and is forgotten, you must
call Technical Support to have it reset back to the default password.
For Technical Support contact info, refer to “Contacting Allied
Telesyn” on page 12.
Accessing the
Management
Software
There are three ways to access the management software on a
Converteon™ chassis. These methods are referred to in this guide as
management sessions. They are:
ˆ Local management session, as described in “Local Management
Session” on page 16.
ˆ Telnet management session, as described in “Telnet Management
Session” on page 17.
ˆ SNMP management session, as described in “SNMP Management
Session” on page 18.
You can configure one or more of these methods to enhance the security
of the chassis by preventing unauthorized changes to the module and port
configurations.
Configuring
Management
Access
To enable or disable a management access method, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu, shown in Figure 3 on page 28, is
displayed.