Allied Telesis AT-S70 - Manual (Page 107)

AT-S70 Management Software User’s Guide
107
OAM Loopback Test
This section contains the procedures on how to manage the OAM
loopback test.
Enabling or
Disabling Remote
Loopback Test
To enable or disable the OAM remote loopback test, perform the following
procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu, shown in Figure 41 on
page 94, is displayed.
2. Select a line card on which you want to configure.
3. Press .
The Module Configuration Menu, shown in Figure 42 on page 95, is
displayed.
4. Select the port that you want to configure the OAM operations on.
5. Press .
The Port Management Menu, shown in Figure 43 on page 95, is
displayed.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu, shown in Figure 44 on page 96, is
displayed.
7. From the OAM Configuration Menu, select the OAM Loopback Test
Menu.