Allied Telesis AT-S70 User Manual
Page 101
AT-S70 Management Software User’s Guide
101
Converteon™ chassis is not part of the IEEE802.3ah end points.
(i.e. in this mode, the OAM function of the line card is disabled). To
configure as OAM bypass mode, the module will pass all
OAMPDUs whose vendor OUI is not Allied Telesyn.
OAM Visible Mode – In this mode, the line card does respond to
OAMPDU packets. In an unmanaged chassis, the line card will be
in passive mode. In a managed chassis, the line card can either be
in passive or active mode depending on how it is software
configured. For detailed information, refer to “OAM Active and
Passive Mode Behaviors” on page 92. To configure as OAM visible
mode, the module will respond to all OAMPDUs.(default)
Operation Status
Indicates the OAM operational status. Possible values are:
Disabled – The OAM operation has been disabled.
Passive Wait – A station configured in Passive mode waits until
receiving information OAMPDUS with Local Information TLVs
before sending any Information OAMPDU with Local Information
TLVs. By waiting until first receiving an Information OAMPDU with
the Local Information.
Active Send Local – A station configured in Active mode sends
Information OAMPDUs that only contain the Local Information
TLV. While in this state, the local station waits for Information
OAMPDUs received from the remote station.
Send Local and Remote – The flow of frames is generated within
the local and remote stations and across the link during loopback.
OAM Peering Locally Rejected – The configuration of the peer
OAM entity has been rejected by the remote station.
OAM Peering Remotely Rejected – The configuration of the peer
OAM entity has been rejected by the local station.
Operational – The OAM operation is in operational mode. (default)
Mux State
Governs the flow of frames from the MAC Client through the
multiplexer function. Possible values are:
Forward – Multiplexer passes MAC Client frames to subordinate
sublayer. (default)
Discard – Multiplexer discards MAC Client frames.
Parser State
Indicates the state of the parser function in the OAM peer as reflected
in the latest OAMPDU. This value is changed based on loopback
actions by either the local or remote station. Possible values are:
Forward – Parser passes received non-OAMPDUs to superior
sublayer. (default)