Allied Telesis AT-S70 - Manual (Page 18)

Chapter 1: Overview
18
SNMP Management Session
The Converteon™ chassis can also be remotely managed via Simple
Network Management Protocol (SNMP), such as HP Openview. This
method, however, does not use the management interface.
If you intend to manage the chassis from a management workstation using
an SNMP management program, you need to load the Management
Information Base (MIB) file onto the management workstation. (The MIB
file is available from the Allied Telesyn web site.) This requires that you
use a MIB compiler to compile the file. To load the MIB file onto a
management workstation, follow the instructions included with your MIB
compiler. For instructions on how to compile the MIB file with your SNMP
program, refer to your SNMP management documentation.
A familiarity with Management Information Base (MIB) objects is
necessary for this type of management.
The AT-S70 software supports the following MIB:
ˆ atcv5000.mib
For non-IP environments, you can use a MAC address to connect to a
remote system as long as there are no routers between the two chassis.