Allied Telesis AT-S70 - Manual (Page 35)

AT-S70 Management Software User’s Guide
35
Configuring Basic Chassis Parameters
The AT-S70 management software provides options to configure some
basic parameters on the chassis.
This section contains the following procedures:
ˆ “Assigning an IP Address” on page 34
ˆ “Naming the System” on page 35
ˆ “Setting the System Date and Time” on page 36
ˆ “Configuring the System Location and Contact Information” on page 37
ˆ “Configuring the IP Address, Subnet Mask, and Default Gateway” on
page 38
ˆ “Configuring the Manager IP Addresses” on page 39
ˆ “Configuring SNMP Community Strings” on page 39
ˆ “Enabling and Disabling DHCP” on page 40
Naming the
System
To set the chassis name, perform the following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu, shown in Figure 5, is displayed.
Figure 5. System Configuration Menu
System Configuration Menu
System Name: Converteon
System Date (mm/dd/yy) 00/00/00
System Time (hh:mm:ss) 00:16:32
Omega Options
IP Parameters
Terminal Configuration
Temperature Threshold Configuration
Return to Main Menu...