Allied Telesis AT-S70 - Manual (Page 108)

Chapter 8: Operations, Administration, and Maintenance (OAM)
108
The OAM Loopback Test Menu, shown in Figure 49, is displayed.
Figure 49. OAM Loopback Test Menu
8. From the OAM Loopback Test Menu, select Enable Remote
Loopback to enable the remote loopback, or select Disable Remote
Loopback to disable the remote loopback test. The default is
disabled.
When remote loopback is enabled, the local MAC Client stops sending
data frames to the remote station and the local OAM Client sets its
action parameter to DISCARD.
9. Press or select the “Return to ...” option at the bottom of the
menu, to save the settings and return to the previous menu.
Starting or
Stopping
Loopback Test
To start or to terminate the OAM loopback test, perform the following
procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu, shown in Figure 41 on
page 94, is displayed.
2. Select a line card on which you want to configure.
3. Press .
The Module Configuration Menu, shown in Figure 42 on page 95, is
displayed.
4. Select the port that you want to configure the OAM operations on.
5. Press .
OAM Loopback Test
Module = 5, Port = 1
Enable Remote Loopback
> Disable Remote Loopback
Start Loopback Test
> Stop Loopback Test
Show Loopback Test Statistics
Clear Loopback Test Statistics
Return to OAM Configurations ...