Allied Telesis AT-S70 - Manual (Page 20)

Chapter 2: Starting a Local or Telnet Management Session
20
Using the Terminal Interface
If you are using a DEC VT100 or ANSI (the default) terminal configuration,
it is helpful to know how to select a menu option in the terminal interface.
Table 1 lists the instructions on how to move through the menus and
select menu options.
Enabled options in menus are preceded with a > symbol. In the following
example, the first option is enabled:
>Enable this port
Disable this port
When you press to select a field in which you can enter a value,
the -> symbol is displayed. For example:
System name: ->
The -> symbol indicates that you can enter a new value for the parameter
or change the existing value. Once you have entered a value, press
. Parameter changes are immediately activated on a
Converteon™ module.
Table 1. Menu Selection Options
When directed to You must
Select an option Highlight the option by pressing the Up ( ↑ ) or
Down ( ↓ ) arrow key; then press
or
Type the first character of the desired option at
the prompt and press .
If two or more options have matching initial
characters, type the initial characters until the
option you want is highlighted; then press
.
Enter information (for
example, the IP address
of a chassis) Type the information and press .
Return to the previous
screen Press or select the “Return to...” option at
the bottom of the menu.