Allied Telesis AT-S70 - Manual (Page 17)

AT-S70 Management Software User’s Guide
17
Telnet Management Session
You can use any management workstation on your network that has the
Telnet application protocol to manage a Converteon™ chassis. This type
of management session is referred to in this guide as a remote
management session because you do not have to be in the wiring closet
where the chassis is located. You can manage the chassis from any
workstation on the network that has the application protocol.
To establish a Telnet management session with a chassis, there must be
at least one Converteon™ chassis that has been assigned an Internet
Protocol (IP) address. Only one chassis in a subnet needs to have an IP
address.
Note
For instructions on how to start a Telnet management session, refer
to “Starting a Telnet Management Session” on page 24.
A Telnet management session gives you access to nearly all operating
parameters of a chassis. You can perform nearly all the same functions
from a Telnet management session as you can from a local management
session.