Allied Telesis AT-S70 - Manual (Page 45)

AT-S70 Management Software User’s Guide
45
Resetting and Restarting the System
When you reset a system, the system is also restarted. Resetting and
restarting the system is a way to refresh all the statistics displays or
overcome system errors. This process does no affect any system settings
or return the system to its default values. However, it does terminate your
management session and you must log in again after the reset is
complete.
Note
If DHCP is enabled, then the IP address of the Converteon™
chassis MAY change after a rest or power cycle. For more
information on how to enable DHCP, refer to “Enabling and
Disabling DHCP” on page 40.
To reset a chassis, perform the following procedure:
1. From the Main Menu, select Administration.
The Administration Menu, shown in Figure 8 on page 43, is displayed.
2. From the Administration Menu, select Reset Chassis and Restart
Line Cards.
The Reset Chassis window, shown in Figure 10, is displayed.
Figure 10. Reset Chassis Window
3. From the Reset Chassis window, select Yes to reset the system or No
to cancel the command.
Note
Resetting the chassis also resets the line cards; therefore the traffic
stops momentarily during the reset.
Converteon
Do reset chassis now? (Yes or No):
Yes
> No
Return to Administration Menu...