Allied Telesis AT-S70 - Manual (Page 39)

AT-S70 Management Software User’s Guide
39
Configuring the
Manager IP
Addresses
You can specify up to four network management workstations that will
receive SNMP traps from the system.
To configure the management IP addresses, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu, shown in Figure 5 on page 35, is
displayed.
2. From the System Configuration Menu, select IP Parameters.
The IP Parameters Menu, shown in Figure 6 on page 37, is displayed.
3. Adjust the following parameters as necessary:
Manager address(es)
This parameter specifies up to four IP addresses of network
management workstations that will receive SNMP traps from the
chassis. This is optional.
4. Press or select the “Return to ...” option at the bottom of the
menu, to save the settings and return to the previous menu.
Configuring
SNMP
Community
Strings
To configure the SNMP community strings, perform the following
procedure:
Note
SNMP access is disabled by default. To enable SNMP access, refer
to “Configuring Management Access” on page 31.
1. From the Main Menu, select System Configuration.
The System Configuration Menu, shown in Figure 5 on page 35, is
displayed.
2. From the System Configuration Menu, select IP Parameters.
The IP Parameters Menu, shown in Figure 6 on page 37, is displayed.
3. Adjust the following parameters as necessary.
Get community string
The default setting for this string is “public.”
Set community string
The default setting for this string is “private.”
Trap community string
The default setting for this string is “public.”