Allied Telesis AT-S79 - Manual (Page 98)

Chapter 9: Dial-in User Configuration
98 Section I: Using the Menus Interface
3. Type A to select Add User.
The following prompt is displayed:
Enter dial-in user name >
4. Type a name of a dial-in user. Then press Enter.
You can enter up to 23 alphanumeric characters. Special characters
are permitted.
The following prompt is displayed:
Enter dial-in user password >
5. Type the password of the dial-in user.
You can enter up to 23 alphanumeric characters. Special characters
are permitted.
The following prompt is displayed:
Enter dial-in user dynamic VLAN ID >
6. Assign the dial-in user to a VLAN by entering a VID.
The range for the VID is from 1 to 4,000.
7. Type Q to select Quit to previous menu and save your changes.
Deleting a Dial-in
User
To delete a dial-in user, perform the following procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type D to select
Dial-in User Configuration.
The Dial-in User Configuration Menu is shown in Figure 22 on page
97.
3. Type type D to select Delete User.
The following prompt is displayed:
Enter dial-in user name >