Allied Telesis AT-S79 - Manual (Page 185)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 185
Configuring IP Access List
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
ˆ “Enabling or Disabling IP Access List” on page 185
ˆ “Adding or Removing IP Addresses” on page 186
Enabling or
Disabling IP
Access List
To enable or disable the IP Access List feature, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type L to select IP Access
List.
The IP Access List Menu is shown in Figure 45.
Figure 45. IP Access List Menu
Basic Switch Configuration -> IP Access List Menu
IP Restriction: Disabled
Accessible IP Accessible IP Accessible IP Accessible IP
------------- ------------- ------------- -------------
100.10.10.4
[Q]uit to previous menu
-------------------------------------------------------------
Set IP Restriction [S]tatus
Set [I]P Address
[Q]uit to previous menu
Command>