Allied Telesis AT-S79 - Manual (Page 113)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 113
9. Type the name of the VLAN group. The VLAN name can contain up to
32 characters including spaces. Then press Enter.
10. Type Q to select Quit to previous menu and save your changes.
Changing the
PVID
To change the value of a VLAN’s PVID, perform the following procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 23 on page 107.
3. Type V to select 802.1Q VLAN.
The Tagged-based VLAN configuration Menu is shown in Figure 24 on
page 108.
4. Type S to select Set Port Config.
The VLAN Port Configuration Menu is shown in Figure 23 on page 107
5. Type V to select Set Port VID.
The following prompt is displayed:
Set PVID-> Enter port number
6. Type the number of the port whose PVID value you want to change
and press Enter. You can configure only one port at a time.
The following prompt is displayed where n indicates the port number
that you selected in the previous step:
Enter PVID for port n >
7. Type the new PVID for the port and press Enter. The PVID should
equal the VID of the VLAN where you want the port to be an untagged
member.
Note
If you specify a PVID that does not correspond to any VIDs on the
switch, the management software creates a new VLAN with a VID
that equals the PVID. The VLAN is not assigned any name.
8. Repeat steps 4 through 6 to configure additional ports.