Allied Telesis AT-S79 - Manual (Page 87)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 87
You can add more than one group member at a time. You can specify
the values individually (for example, 2,5,11), as a range (for example,
4-7), or both (for example., 2,5,11-15).
6. Type Q to select Quit to previous menu and save your changes.
Deleting a Static
Member Port
To delete a group from a Group MAC address, perform the following
procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type A to select Static
Multicast Address Configuration.
The Static Multicast Address Table Menu is shown in Figure 20 on
page 85.
3. Type D to select Delete Static Member Port.
The following prompt is displayed:
Enter MAC address for multicast entry >
4. Type a multicast MAC address. Then press enter. The range of
acceptable multicast MAC addresses is from 01:00:5E:00:01:00 to
01:00:5E:7F:FF:FF.
The following prompt is displayed:
Select group member >
5. Enter a group member in the range of 1 to 24.
You can add more than one group member at a time. You can specify
the values individually (for example, 2,5,11), as a range (for example,
4-7), or both (for example., 2,5,11-15).
6. Type Q to select Quit to previous menu and save your changes.