Allied Telesis AT-S79 - Manual (Page 134)

Chapter 11: Simple Network Management Protocol (SNMP)
134 Section I: Using the Menus Interface
4. Type A to select Add New Host Entry.
The following prompt is displayed:
Enter entry number>
a. Enter a value between 1 and 10. Then press Enter.
The following prompt is displayed:
Enter IP address for host>
b. Enter an IP address for an SNMP community that you previously
defined in the Community Configuration menu. The IP address
format must be in the xxx.xxx.xxx.xxx format. See “Creating an
SNMP Community” on page 128.
The following prompt is displayed:
Enter community name>
c. Enter the community name for an existing SNMP community that
you previously defined in the Community Configuration menu. See
“Creating an SNMP Community” on page 128.
5. Type Q to select Quit to previous menu and save your changes.
Deleting an Host
Entry
To delete an entry from the Host Community Menu, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. From the SNMP Configuration Menu, type H to select Host
Configuration.
The Host Configuration Menu is displayed in Figure 31 on page 133.
4. Type D to select Delete Host Entry.
The following prompt is displayed:
Enter entry number>
a. Enter the number of the SNMP community that you want to
remove from the list of SNMP hosts. Then press Enter.