Allied Telesis AT-S79 - Manual (Page 291)

AT-S79 Management Software User’s Guide
Section II: Using the Web Browser Interface 291
Modifying an SNMP Community
Use the following procedure to modify an existing SNMP community in the
Community Table.
1. From the bookmarks on the left side of the page, select Bridge.
2. From the Bridge folder, select SNMP.
3. From the SNMP folder, select Community Table.
The Community Table page is shown in Figure 84 on page 290.
4. To change the access level of an SNMP community, select the pull-
down menu under the Access column in the Community table for the
community you want to modify. Select Read-Only access or Read-
Write access.
5. To change the community name, type over an existing community
name. Then click Apply.
Note
You cannot change the index number of an SNMP community.