Allied Telesis AT-S79 - Manual (Page 110)

Chapter 10: Virtual LANs
110 Section I: Using the Menus Interface
10. Type T to indicate a tagged port or U to indicate an untagged port.
11. When the VLAN is complete, type A to select Apply and apply the
VLAN settings.
The Tagged-based VLAN Configuration Menu is displayed again with
information about the VLAN you just created. The VLAN is now active
on the switch.
12. If the VLAN contains untagged ports, perform the next procedure,
“Configuring the PVID of Untagged Ports” on page 111, to change the
PVID of the untagged ports to match the virtual LAN’s VID.
13. Type N to select Set VLAN Name.
The following prompt is displayed:
Set VLAN Name -> Enter VLAN Name >
14. Type a name for the VLAN and press Enter. The VLAN name can
contain up to 32 characters including spaces.
15. Type Q to select Quit to previous menu and save your changes.