Allied Telesis AT-S79 - Manual (Page 189)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 189
Configuring Destination MAC Filtering
The procedures in this section describe how to add or remove MAC
addresses from the Destination MAC filtering addresses. See the following
procedures:
ˆ “Setting Destination MAC Filtering” on page 189
ˆ “Removing Destination MAC Filtering Addresses” on page 190
Setting
Destination MAC
Filtering
To add a MAC address to the destination MAC filtering addresses on the
switch, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 34.
2. From the Basic Switch Configuration menu, type F to select
Destination MAC Filter.
See the Destination MAC Filter Menu in Figure 46.
Figure 46. Destination MAC Filter Menu
3. To add a destination MAC address filter, type A to select Add MAC
Address.
The following prompt is displayed:
Add MAC Address to filter >
Basic Switch Configuration -> Destination MAC Filter
MAC Address MAC Address MAC Address MAC Address
----------- ----------- ----------- ------------
-----------------------------------------------------
[N]ext Page
[A]dd MAC Address [Q]uit to previous menu
[P]revious Page [R]emove MAC Address
Command>