Allied Telesis AT-S79 - Manual (Page 290)

Chapter 30: Simple Network Management Protocol (SNMP)
290 Section II: Using the Web Browser Interface
Creating an SNMP Community
This procedure explains how to create an SNMP community.
To create an SNMP community, perform the following procedure:
1. From the bookmarks on the left side of the page, select Bridge.
2. From the Bridge folder, select SNMP.
3. From the SNMP folder, select Community Table.
The Community Table page is shown in Figure 84.
Figure 84. Community Table Page
4. Type an available entry number from 1 through 8 next to the Entry
number field.
5. To select the read/write access for the community, use the pull-down
menu next to the Access field to select Read-Only access or Read-
Write access.
6. Type the name of the new SNMP community in the Community field.
Then click Add.
Enter a name between 1 and 20 characters in length.