Allied Telesis AT-S79 - Manual (Page 115)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 115
Displaying the VLANs
To display a list of the port-based and tagged VLANs on the switch,
perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 23 on page 107.
3. Type V to select 802.1Q VLAN.
The Tagged-based VLAN configuration Menu is shown in Figure 24 on
page 108. The currently configured VLANs are displayed in a table
with the following columns of information:
VLAN ID
The ID of the VLAN.
VLAN Name
The name of the VLAN.
VLAN Type
The type of VLAN, either permanent or static. Only the Default VLAN is
permanent. All other port-based and tagged VLANs are static.
4. To view the ports of a VLAN, type O to select Config VLAN Member.
The following prompt is displayed:
Enter VLAN ID >
5. Enter the VID of the VLAN you want to view and press Enter.
The range of the VID is from 2 to 4094.