Allied Telesis AT-S79 - Manual (Page 294)

Chapter 30: Simple Network Management Protocol (SNMP)
294 Section II: Using the Web Browser Interface
Modifying a Host Table Entry
Use the following procedure to modify an entry in the Host Table.
1. From the bookmarks on the left side of the page, select Bridge.
2. From the Bridge folder, select SNMP.
3. From the SNMP folder, select Host Table.
The Host Table page is shown in Figure 85 on page 293.
4. To change the IP Address, type in the new IP address in the Host
Table.
5. To change the community name, use the pull-down menu to select a
new community name in the Host Table.
6. To activate your changes on the switch, click Apply next to the entry
that you want to modify.