Allied Telesis AT-S79 - Manual (Page 320)

Chapter 34: Dial-in User
320 Section II: Using the Web Browser Interface
Adding a Dial-in User
This procedure explains how to add a Dial-in User on the switch. For each
user, you must assign an user name, password, and a VLAN.
To configure a Dial-in user, perform the following procedure:
1. From the bookmarks on the left side of the page, select Security.
2. Select Dial-in User.
The Dial-in User Page is shown in Figure 94.
Figure 94. Dial-in User Page
3. To create a new user, enter a user name in the User Name field.
You can enter an alphanumeric value of up to 23 characters. Special
characters are permitted.
4. To assign a password to the user name, enter a password in the
Password field.
You can enter an alphanumeric value of up to 23 characters. Special
characters are permitted.
5. Assign the user name to a VLAN, by entering a VLAN to the Dynamic
VLAN field.
Enter a value between 1 and 4,000. Type “0” to ignore this field.
6. Click Add to save the user information.