Allied Telesis AT-S79 - Manual (Page 130)

Chapter 11: Simple Network Management Protocol (SNMP)
130 Section I: Using the Menus Interface
4. To add a new community, type A to select Add New Community
Entry.
The following prompt is displayed:
Enter entry number>
a. Type an available entry number from 1 through 8.
The following prompt is displayed:
Enter community name>
b. Type the name of the new SNMP community.
The following prompt is displayed:
Enter community access (R/W)>
c. Enter R to indicate Read-Only access and W to indicate
Read-Write access.
5. Type Q to select Quit to previous menu and save your changes.
The new SNMP community is now operational on the switch.
Deleting an
SNMP
Community
To delete an SNMP community, perform the following procedure.
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. Type D to select Delete Community Entry.
The following prompt is displayed:
Enter entry number>
a. Enter the number of the SNMP community (from 1 through 8) that
you want to delete followed by Enter.
The entry is removed from the Community Configuration Menu.
4. Type Q to select Quit to previous menu and save your changes.