Allied Telesis AT-S79 - Manual (Page 324)

Chapter 35: RADIUS Authentication Protocol
324 Section II: Using the Web Browser Interface
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Security folder, select RADIUS.
The RADIUS page is shown in Figure 95.
Figure 95. RADIUS Page
2. To enter the RADIUS server’s IP address, enter the address in the
Server IP Address field.
3. To specify the server’s encryption key, click the Shared Secret field
and enter the encryption key.
4. To select the port number that you want to assign to UDP, type in the
port number in the Server Port field. You may only assign one port
number to this parameter. The default value is 1812.
5. Click Apply to save your changes.