Allied Telesis AT-S79 - Manual (Page 131)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 131
Modifying an
SNMP
Community
Use the following procedure to modify an existing SNMP community.
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on
page 128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. Type M to select Modify Community Entry.
The following prompt is displayed:
Enter entry number>
a. Enter the entry number (from 1 through 8) that you want to modify.
Then press Enter.
The following prompt is displayed:
Choose which to be modified (A/C/B)?
Note
In the above prompt, A represents access level, C represents
community name, and B represents both the access level and
community name.
b. Select A to modify the access level of a community.
The following prompt is displayed:
Enter community access (R/W)>
c. Enter R to indicate Read-Only access and W to indicate Read-
Write access.
The Community Configuration Menu is updated with the new access
level.
4. Select C to change the community name.
The following prompt is displayed:
Enter entry number>
a. Enter a number from 1 through 8.