Allied Telesis AT-S79 - Manual (Page 228)

Chapter 21: Basic Switch Parameters
228 Section II: Using the Web Browser Interface
Setting Up the IP Access List
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
ˆ “Creating an IP Access List” on page 228
ˆ “Deleting an IP Address” on page 229
For background information regarding the IP Access List feature, see
Chapter 15, “IP Access List” on page 183.
Creating an IP
Access List
To create a list of restricted IP addresses, perform the following
procedure:
1. Click on the System folder.
2. From the System folder, select IP Access List.
The IP Access List Page is shown in Figure 59.
Figure 59. IP Access List Page
3. To set the IP restriction status, select Disable or Enable in the pull-
down menu next to the IP Restriction Status field. Then click Apply.
By default, the IP Restriction Status field is set to Disable.
4. Enter an IP address that you want to prevent from accessing the
switch in the xxx.xxx.xxx.xxxx format next to the IP Address field.
Then click Add.
The IP address is added to the IP Access List Table.