Allied Telesis AT-S79 - Manual (Page 118)

Chapter 10: Virtual LANs
118 Section I: Using the Menus Interface
Modifying a VLAN
This procedure allows you to perform the following functions:
ˆ Change the name of a VLAN.
ˆ Add or remove tagged ports from a VLAN.
Before performing this procedure, note the following:
ˆ You cannot change the VID of a VLAN.
ˆ You cannot add an untagged port to a VLAN with this procedure. That
function requires changing a port’s VID value, as explained in
“Configuring the PVID of Untagged Ports” on page 111
ˆ You cannot remove an untagged port from a VLAN with this procedure.
To remove an untagged port from a VLAN, you must assign it as an
untagged member of another VLAN by changing its PVID, as
explained in “Configuring the PVID of Untagged Ports” on page 111.
To change the name of a VLAN or to add or remove tagged ports, perform
the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
The VLAN Management Menu is shown in Figure 23 on page 107.
3. Type V to select 802.1Q VLAN.
The Tagged-based VLAN configuration Menu is shown in Figure 24 on
page 108.
4. Type O to select C[o]nfig VLAN Member.
The following prompt is displayed:
Enter VLAN ID >
5. Type the number of the VLAN you want to modify and press Enter.
The range of the VID is from 2 to 4094.
The Config VLAN Member menu is shown in Figure 27 on page 116.