Allied Telesis AT-S79 - Manual (Page 141)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 141
h. Enter a previously defined community name followed by Enter. See
“Adding an SNMP Community” on page 128.
i. Type A to change the trap version, IP address, and community
name. Then press Enter.
The following prompt is displayed:
Enter trap version (1/2) >
j. Type the trap version and then press Enter. Select 1 for SNMP
version 1 or select 2 for SNMP version 2vc.
The following prompt is displayed:
Enter IP address for host >
k. Enter an IP address in the xxx.xxx.xxx.xxx format.
The following prompt is displayed:
Enter community name >
l. Enter a previously defined community name followed by Enter. See
“Adding an SNMP Community” on page 128.
The Trap Receiver Configuration Menu is updated.
5. Type Q to select Quit to previous menu and save your changes.
Enabling or
Disabling Traps
To enable or disable a trap, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. From the SNMP Configuration Menu, type T to select Trap Receiver
Configuration Menu.
The Trap Receiver Configuration Menu is displayed in Figure 31 on
page 133.
4. Type E to select Enable/Disable Authentication Trap.
The following prompt is displayed:
Enable or Disable SNMP Authentication Trap (E/D) >