Campbell Scientific CR800 and CR850 Measurement and Control Systems - Manual (Page 515)

Appendix B. Status Table and Settings
515
Table 117. Status-Table Fields and Descriptions
Fieldname Description Variable Type Default Range Edit? Info Type
pppInterface
Controls which datalogger
port PPP service is
configured to use. Warning:
If this value is set to CS I/O
ME, do not attach any other
devices to the CS I/O port.
Integer 0 (Inactive)
pppIPAddr
Specifies the IP address that
is used for the PPP interface
if that interface is active (the
PPP Interface setting needs
to be set to something other
than Inactive).
String 0.0.0.0
pppUsername
Specifies the user name that
is used to log in to the PPP
server.
String
pppPassword
Specifies the password that is
used to log in to the PPP
server.
String
pppDial
Specifies the dial string that
follows ATD (e.g., #777 for
Redwing CDMA) or a list of
AT commands separated by
';' (e.g., ATV1;
AT+CGATT=0;ATD*99***
1#), that are used to initialize
and dial through a modem
before a PPP connection is
attempted. A blank string
means that dialing is not
necessary before a PPP
connection is established.
String
pppDialResponse
Specifies the response
expected after dialing a
modem before a PPP
connection can be
established.
String connect Yes
Messages
Contains a string of messages
that can be entered by the
user.
String Yes
CalGain
19
Calibration table of gain
values. Each integration /
range combination has a gain
associated with it. These
numbers are updated by the
background slow sequence.
Float array of 18 Calib
CalSeOffSet
19
Calibration table of single-
ended offset values. Each
integration / range
combination has a single-
ended offset associated with
it. These numbers are
updated by the background
slow sequence if needed in
the program.
Integer array of 18 close to 0 Calib