Campbell Scientific CR800 and CR850 Measurement and Control Systems - Manual (Page 514)

Appendix B. Status Table and Settings
514
Table 117. Status-Table Fields and Descriptions
Fieldname Description Variable Type Default Range Edit? Info Type
Beacon
Array of Beacon intervals (in
seconds) for comms ports.
Aliased to:
BeaconRS-232
BeaconME
BeaconSDC7
BeaconSDC8
BeaconSDC10
BeaconSDC11
BeaconCOM1
BeaconCOM2
Integer array of 9 0
0 - approx.
65,500
Yes Config PB
Verify
Array of verify intervals (in
seconds) for com ports.
Aliased to
VerifyRS-232
VerifyME
VerifySDC7
VerifySDC8
VerifySDC10
VerifySDC11
VerifyCOM1
VerifyCOM2
Integer array of 9 0
0 - approx.
65,500
Status
MaxPacketSize
Maximum number of bytes
per data collection packet.
_ 1000
USRDriveSize
Configures the USR: drive. If
0, the drive is removed. If
non-zero, the drive is created.
Integer 0 8192 Min Yes Mem
IPInfo
Indicates current parameters
for IP connection.
String
IPAddressEth
Specifies the IP address for
the Etnernet interface. If
specified as zero, the address,
net mask, and gateway are
configured automatically
using DHCP.
Entered as String /
Stored as 4 byte
0.0.0.0
All valid IP
addresses
Yes
IPGateway
Specifies the address of the
IP router to which the CR800
will forward all non-local IP
packets for which it has no
route.
Entered as String /
Stored as 4 byte
0.0.0.0
All valid IP
addresses
Yes
TCPPort
Specifies the port used for
Ethernet socket
communications.
Long 6785 0 - 65535 Yes