Horner APG XLt OCS - Manual (Page 57)

MAN0878-04-EN CH. 11
August 12, 2009 Page 57 of 100 ECN # 979
Set Serial Ports
The Set Serial Ports Sub-Menu displays three System Settings, all of which are editable, and one optional
item. For the Dflt Pgm Port System Setting, only MJ1-232 can be selected, unless either an Ethernet
(XEC) or a Modem (XMC) COM module is installed. Also, the Set Ethernet (Enet) item only appears if
an Ethernet COM module is installed.
Dflt Pgm Port: MJ1-232 = MJ1 RS232 port is the default programming port
Enet = Ethernet COM module is the default programming port
Modem = Modem COM module is the default programming port
MJ1 RS485 Bias:
No = MJ1 RS485 bias resistors are not switched in
Yes = MJ1 RS485 bias resistors are switched in
MJ2 RS485 Bias:
No = MJ2 RS485 bias resistors are not switched in
Yes = MJ2 RS485 bias resistors are switched in
Set Ethernet (Enet)
= Select and press Enter to setup the Ethernet COM module
Set Ethernet (Enet)
The Set Ethernet (Enet) Sub-Menu displays three System Settings, all of which are editable. The values
shown below are the default values. Note that if Gtwy is set to 0.0.0.0, Ethernet communication will be
confined to the local network.
Addr: 192.168.254.128 = IP Address for installed Ethernet COM module
Mask: 255.255.255.0 = Net Mask for installed Ethernet COM module
Gtwy: 0.0.0.0 = Gateway device IP Address for installed Ethernet COM module
Set Time/Date
The Set Time/Date Sub-Menu displays three System Settings. Time and Date are editable, and Day is
automatically calculated from the Date setting. Note that Time and Date are split into three editable fields
each. Use
← or → to select a field and then use ↓ or ↑ to edit the field.
Time: 10:21:36 = Current time (hours:minutes:seconds in 24-hour format)
Date: 22-Jun-2006 = Current date (day-month-year)
Day: Thursday = Current day of week calculated from the Date setting
Note: After changing the Ethernet Addr, Mask, or Gtwy, the XLe/XLt must be power-cycled (or
reset) before the changes take effect.
XLt Specific:
Set Beeper (XLt only)
The Set Beeper Sub-Menu displays one System Setting, which is editable
Beeper enable: Yes (default)= Enables beeper No = Disables beeper (does NOT affect
ladder access)