Horner APG QX351 OCS HEQX351C103 - Manual

MAN0893-02-EN Specifications / Installation
________________________________________________________________________________________________________________________________________
Feb 2, 2010
Page 1 of 5 #1039
1. Specifications
Table 1 - QX351 Specifications
Display Type (LCD with
Backlight)
5.7” QVGA TFT
Display Size 5.7”
Display Screen Dimensions 320 x 240
Display Memory 2.75MB
User Keys 5 user-defined Function keys and a System key
Screens supported 1023
Colors 32768
Primary power 10 – 30 VDC
Steady state current 500 mA @ 24 VDC
Inrush current
30 A for 1 ms @ 24 VDC – DC Switched
2.5 A for 4 ms @ 24 VDC - AC Switched
Product Descriptions
Height 5.653” (143.6mm)
Width 7.326” (186.1mm)
Depth 2.2” (55.88mm)
Serial Ports RS232 & RS485. Software Selectable
Terminal Type Screw Type, 5mm removable
Weight 23.3 oz (0.66kg)
Portable Memory Micro SD card slot
Temperature & Humidity -10 ° C to +60 ° C & 5 to 95% Non-condensing
Clock Accuracy
+/- 35 ppm maximum at 25 ° C
(+/- 1.53 Minutes per Month)
CE
UL See Compliance Table at
http://www.heapg.com/Pages/TechSupport/Product
Cert.html
Connectivity
Smart Stack Modules Provides a wide variety of I/O options for the QX.
Requires little space and are easy to install.
Supports upto 2 smartstacks
Fiber Optic Extension System
(FOX) Extends a high-speed QX backplane enabling
SmartStack I/O Modules to be mounted several
meters from the QX. The FOX, also, significantly
increases the number of SmartStack I/O modules
supported by one QX.
SmartStix Modules It is a family of remote I/O products for the QX.
Serial Ports 2 Serial Ports – RS232 & RS485
Ethernet Ethernet (10/100 Mbps)
USB USB networking port for communication with PC’s
and programming of controller
Removable Media Removable Media for up to two gigabytes of
storage of programs, data logging or screen
captures
QX351 Models:
HE-QX351 / HEQX351C103
QX351
2. Installation
1. Prior to mounting, observe requirements for the panel layout design
and spacing/clearances in the OCS QX351 Manual (MAN0892).
2. Cut the host panel.
3. Insert the OCS through the panel cutout (from the front). The
gasket material needs to be between the host panel and the OCS
Caution: Do not force the OCS into the panel cutout. An incorrectly
sized panel cutout can damage the touch screen .
4.
Install and tighten the mounting clips (provided with the OCS) until
the gasket material forms a tight seal.
Caution: Do not over-tighten. Over-tightening damages the case
5. Connect cables as needed such as communications, programming,
power and CsCAN cables to the ports using the provided
connectors.
6. Begin configuration procedures.