HP StorageWorks XP Remote Web Console Software User Manual
Page 94
94
Configuring arrays and logical paths
Removing the relationship between primary and secondary arrays
To remove the relationship between primary and secondary arrays and remove all logical paths between
the two arrays, the primary and secondary array administrators must perform the following procedure:
1.
Ensure that all affected Continuous Access XP Journal volume pairs have been deleted.
2.
Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
3.
Display the DKC Operation pane.
4.
In the Switch Display box, select DKC.
5.
Select Subsystem from the tree. The list displays remote arrays.
6.
Select and right-click the remote arrays from the list.
7.
Select DKC Operations and Delete DKC. A confirmation message appears.
8.
Click OK to close the message.
9.
In the Preset list, check the settings you made.
• The Preset list displays the specified remote arrays. One row indicates one remote array.
• To cancel removal of the relationship, right-click the remote array in the Preset list, and select
Cancel.
10.
Click Apply to remove the relationship.
Initialization Failed
An error occurred with the initialization of the connection between the local and remote
array. Probable causes are:
•
No cable is connected to the local array.
•
No cable is connected to the remote array.
•
No cable is connected to the network device that comes between the local and
remote arrays.
Communication Time
Out
This status indicates one of the following:
•
A timeout error occurred between the primary and secondary arrays.
•
A logic error was detected between the primary and secondary arrays.
Resource Shortage
(Port)
The local array rejected the function for configuring logical path connection. All logical
path resources in the local array might be used for other connections.
Resource Shortage
(Pair-Port)
The remote array rejected the function for configuring logical path connection. All
logical path resources in the remote array might be used for other connections.
Serial Number
Mismatch
The serial number of the array connected to this logical path does not match the serial
number specified by the Add DKC pane.
Invalid Port
The port is not an initiator port.
Pair-Port Number
Mismatch
This status indicates one of the following:
•
The specified port number is incorrect.
•
The port in the remote array is physically disconnected from the local array.
Pair-Port Type
Mismatch
The port on the remote array is not an RCU target port.
Communication Failed
A communication timeout error has occurred on the path between the primary and
secondary arrays.
Table 25
Logical path status (continued)
Status
Remarks