HP StorageWorks XP Remote Web Console Software - Manual (Page 128)

128 Performing Continuous Access XP Journal pair operations
NOTE:
• The Display Filter settings (see ” Filtering information in the list on the Pair Operation pane ” on
page 119) can affect how Previous or Next is recognized.
• The list displays a maximum of 1,024 rows at once. The Previous and Next buttons on the
Pairdisplay pane can only be used for the currently displayed 1,024 rows.
• Refresh: Updates the pair status information.
• Close: Closes the Pairdisplay pane.
Changing options for data volume pairs
Use the Change Pair Option pane to change options for a pair of data volumes.
Only the primary array’s administrator can perform the following operation. The secondary array’s
administrator cannot perform the following operation.
1. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks XP
Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Display the Pair Operation pane (see ” Displaying the Pair Operation pane ” on page 115).
3. In the list, select and right-click the desired pairs.
CAUTION: You can change options only for pairs in PAIR, PSUS, or PSUE status. If you select a
pair in another status, you cannot continue with the subsequent steps.
4. Select Change Pair Option. The Change Pair Option pane appears ( Figure 56 ).
5. Change pair options, and click Set.
NOTE: If you select two or more pairs in the list, the list on the pane might display blanks for
option values. If you do not want to change the current option value for each pair, ensure that the
list displays blanks. If you select a value other than blank from the list, the selected value is set to
each of the pairs.
6. See the Preset list in the Pair Operation pane to check the settings you made.
• To modify a setting, right-click the setting, and select Modify.
• To cancel a setting, right-click the setting, and select Cancel.
7. Click Apply to apply the changes.
NOTE: If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An error
message appears and gives detailed information about the error.
Figure 56 Change Pair Option pane
• Error Level: Range used for splitting a pair when a failure occurs.