HP StorageWorks XP Remote Web Console Software - Manual (Page 181)

Continuous Access XP Journal user guide 181
Resource Shortage (Port)
or
Resource Shortage (Pair-Port) Array rejected the request for
establishing a logical path because all
resources in the local and remote arrays
are being used for other connections.
Delete the failed path and all paths and
remote arrays not currently in use. The
local array can be connected to up to
64 remote arrays with up to eight paths
to each remote array.
Ensure that all ports on the local and
remote arrays are properly configured:
ordinary target ports or RCU target
ports for hosts, RCU target ports for
remote arrays, initiator ports for local
arrays.
If necessary, connect to the remote
array to delete paths or remote arrays
and reconfigure ports, and reconnect to
the local array. After that, add the path
and remote array again.
Serial Number Mismatch Remote array’s serial number (S/N)
does not match the specified serial
number (S/N).
Ensure that you entered the correct
remote array S/N and path parameters
(for example, local array port, remote
array port, and controller ID). After that,
delete the failed path. You might need
to change the minimum paths setting or
delete the remote array to delete the
path. After deletion finishes, add the
path and the remote array.
Ensure that you entered the correct
controller ID. Ensure that the topology
settings of the local and remote array
ports are correct.
Invalid Port Specified port is not configured as an
initiator port, or this path already exists.
Ensure that the topology settings of the
local and remote array ports are
correct.
Ensure that you entered the correct
remote array S/N and path parameters
(for example, local array port, remote
array port, and controller ID). After that,
delete the failed path. You might need
to change the minimum paths setting or
delete the remote array to delete the
path. After deletion finishes, add the
path and the remote array again.
Port number invalid Specified port number is invalid. The
cable is not connected to the specified
port.
Delete the failed path. Check the
specified port number or cable
connection, and retry.
Communication error Timeout error occurred in the fibre path
between the local and remote arrays.
Delete the failed path, and retry.
Table 34 Troubleshooting problems with status of logical paths (continued)
Pair status Description Corrective action