HP StorageWorks XP Remote Web Console Software - Manual (Page 182)

182 Troubleshooting
Pair-Port Number Mismatch Specified port in the remote array is
physically disconnected from the local
array.
Ensure that you specified the correct
remote array port. Correct the port
number if necessary.
Ensure that the local and remote arrays
are connected by cables to each other.
If the arrays are not by cables, and retry
the operation.
Ensure that the topology settings of
ports on the local and remote arrays
are correct.
Pair-Port Type Mismatch Specified remote array port is not
configured as an RCU target port.
Ensure that the remote array port is
configured as an RCU target port.
Communication Failed Local array is connected to the remote
array successfully, but a logical
communication timeout occurred.
Ensure that the remote array port and
network relay devices (for example,
cables and switches) are properly
configured and functioning.
Logical Blockade Failure occurred at a local array port. Repair the port status on the local array.
Failure occurred at a remote array port. Repair the port status on the remote
array. After that, delete the path using
the Delete Path or Delete DKC
command, and add the path and
remote array again using the Add Path
or Add DKC command.
Failure occurred in the path relay
equipment.
Repair the path relay equipment. After
that, delete the path using the Delete
Path or Delete DKC command, and add
the path and remote array again using
the Add Path or Add DKC command.
Connection cable is physically broken. Replace the broken cable. After that,
delete the path using the Delete Path or
Delete DKC command, and add the
path and remote array again using the
Add Path or Add DKC command.
Program Error Program error detected. Delete the path using the Delete Path or
Delete DKC command, and add the
path and remote array again using the
Add Path or Add DKC command.
Path was not established. Delete the failed path. You might need
to change the minimum paths setting or
delete the remote array to delete the
path. After deletion finishes, add the
path and remote array using the Add
Path or Add DKC command.
Table 34 Troubleshooting problems with status of logical paths (continued)
Pair status Description Corrective action