HP StorageWorks XP Remote Web Console Software - Manual (Page 183)

Continuous Access XP Journal user guide 183
Table 35 Troubleshooting suspended Continuous Access XP Journal pairs
Suspend
type
Applies to Description Corrective action
PSUE, by
RCU
Primary data
volume
Primary array suspended a pair
because the primary array detected an
error condition at the secondary array.
The suspend type for the secondary
data volume is by MCU.
Clear the error condition at the
secondary array or secondary data
volume. To access the secondary data
volume, delete the pair from the
primary array. If data in the secondary
data volume has been changed,
delete the pair from the primary array,
and recreate the pair using the
Paircreate pane. If data in the
secondary data volume has not been
changed, restore the pair from the
primary array.
PSUE,
S-VOL
Failure
Primary data
volume
Primary array detected an error during
communication with the secondary
array or detected an I/O error during
update copy. In this case, the suspend
type for the secondary data volume is
usually by MCU.
Check the path status on the DKC
Status pane (see Table 34 ).
Clear any error conditions at the
secondary array and secondary data
volume. To access the secondary data
volume, delete the pair from the
secondary array. If data in the
secondary data volume has been
changed, delete the pair from the
primary array, and re-create the pair
using the Paircreate pane. If data in
the secondary data volume has not
been changed, restore the pair from
the primary array.
PSUE, MCU
IMPL
Primary data
volume,
secondary data
volume
Primary array could not find valid
control information in its nonvolatile
memory during the IMPL procedure.
This error occurs only if the primary
array is without power for more than
48 hours (power failure and fully
discharged batteries).
Restore the pair (pairresync) from the
primary array. The primary array
performs an initial copy operation in
response to the pairresync request, so
the entire primary data volume is
copied to the secondary data volume.
PSUE, Initial
Copy Failed
Primary data
volume,
secondary data
volume
Primary array suspended this pair
during the initial copy operation. Data
on the secondary data volume is not
identical to data on the primary data
volume.
Delete the pair from the primary array.
Clear all error conditions at the
primary array, primary data volume,
secondary array, and secondary data
volume. Restart the initial copy
operation using the Paircreate pane.
PSUE, MCU
P/S-OFF
Secondary data
volume
Primary array suspended all
Continuous Access XP Journal pairs
because the primary array was
powered off.
None. Primary array automatically
restores these Continuous Access XP
Journal pairs when the primary array
is powered on.