HP ProCurve 520wl Wireless Access Point - Manual (Page 60)

Advanced Configuration
Services
You can configure the following management services:
NOTE
You must reboot the Access Point if you change the HTTP Port or Telnet Port.
Secure Management
Secure Management allows the use of encrypted and authenticated communication protocols such as SNMPv3, and
Secure Socket Link (SSL), to manage the Access Point.
• Enable Secure Management: Enables the further configuration of HTTPS Access, and SNMPv3. After enabling
Secure Management, you can choose to configure HTTPS (SSL) access on the Services tab, and configure
SNMPv3 passwords on the Passwords tab.
SNMP Settings
• SNMP Interface Bitmask: Configure the interface or interfaces (Ethernet, Wireless, All Interfaces) from which
you will manage the AP by way of SNMP. You can also select Disabled to prevent a user from accessing the AP
by way of SNMP.
HTTP Access
• HTTP Interface Bitmap: Configure the interface or interfaces (Ethernet, Wireless, All Interfaces) from which you
will manage the AP by way of the Web interface. For example, to allow Web configuration by way of the Ethernet
network only, set HTTP Interface Bitmask to Ethernet. You can also select Disabled to prevent a user from
accessing the AP from the Web interface.
• HTTP Port: Configure the HTTP port from which you will manage the AP by way of the Web interface. By default,
the HTTP port is 80.
• Enable HTTP Setup Wizard: The Setup Wizard appears automatically the first time you access the HTTP
interface. If you exited out of the Setup Wizard and want to relaunch it, enable this option, click OK, and then close
your browser or reboot the AP. The Setup Wizard will appear the next time you access the HTTP interface.
4-18