HP ProCurve 520wl Wireless Access Point - Manual (Page 31)

Getting Started
10. Connect one end of an Ethernet cable to the AP's Ethernet port. The other end of the cable should not be
connected to any other device until after the installation is complete.
•
Use a straight-through Ethernet cable to connect the AP to a hub, switch, or patch panel.
• Use a cross-over Ethernet cable to connect to a single computer.
11. Configure and test the unit. See Initialization for details.
12. Download the latest software to the unit, if necessary. HP provides access point software updates through the HP
ProCurve website at http://www.hp.com/go/hpprocurve . See Download the Latest Software for details.
2-5