beautypg.com

Command line interface (cli) – HP ProCurve 520wl Wireless Access Point User Manual

Page 161

background image

Command Line Interface (CLI)

DHCP Server Parameters

- Enable or disable dynamic host configuration

Link Integrity Parameters

- Monitor link status

Interface Parameters

- Configure Wireless and Ethernet settings

Wireless Interface Parameters

Wireless Distribution System (WDS) Parameters

- Configure the WDS partnerships

Ethernet Interface Parameters

- Set the speed and duplex of the Ethernet port

Management Parameters

- Control access to the AP’s management interfaces

SNMP Parameters

- Set read and read/write passwords

HTTP (web browser) Parameters

- Set up the graphical web browser interface. If required, enable SSL and

configure the SSL certificate passphrase.

Telnet Parameters

- Telnet Port setup

Serial Port Parameters

- Serial Port setup

TFTP Server Parameters

- Set up for file transfers; specify IP Address, file name, and file type

IP Access Table Parameters

- Configure range of IP addresses that can access the AP

Auto Configuration Parameters

- Configure the Auto Configuration feature which allows an AP to be

automatically configured by downloading a configuration file from a TFTP server during boot up.

Filtering Parameters

Ethernet Protocol Filtering Parameters

- Control network traffic based on protocol type

Static MAC Address Filter Table

- Enable and disable specific addresses

Proxy ARP Parameters

- Enable or disable proxy ARP for wireless clients

IP ARP Filtering Parameters

- Control which ARP messages are sent to wireless clients based on IP settings

Broadcast Filtering Table

- Control the type of broadcast packets forwarded to the wireless network

TCP/UDP Port Filtering

- Filter IP packets based on TCP/UDP port

Alarms Parameters

SNMP Table Host Table Parameters

- Enter the list of IP addresses that will receive alarms from the AP

Syslog Parameters

- Configure the AP to send Syslog information to network servers

Bridge Parameters

Spanning Tree Parameters

- Used to help prevent network loops

Storm Threshold Parameters

- Set threshold for number of broadcast packets

Intra BSS Subscriber Blocking

- Enable or disable peer to peer traffic on the same AP

Packet Forwarding Parameters

- Redirect traffic from wireless clients to a specified MAC address

Security Parameters

- Access Point security settings

Wireless Interface Security Parameters

- Configure WEP encryption settings

MAC Access Control Parameter

- Control wireless access based on MAC address

RADIUS Parameters

Primary and Backup RADIUS Server Table Parameters

- RADIUS Authentication and Accounting information

Rogue Access Point Detection (RAD) Parameters

- Enable and configure Rogue Access Point Detection.

VLAN/SSID Parameters

- Configure mutiple subnetworks based on VLAN ID and SSID pairs.

Other Parameters

IAPP Parameters

- Enable or disable the Inter-Access Point Protocol

SpectraLink VoIP Parameters (802.11b Only)

- Enable or disable SpectraLink Voice over IP feature

C-25