HP ProCurve 520wl Wireless Access Point - Manual (Page 141)

Command Line Interface (CLI)
Figure C-4 Result of “s?” CLI command
Example 3. Display parameters for set and show
Example 3a allows you to see every possible parameter for the set (or show) commands. Notice from example 3a that
the list is very long. Example 3b shows how to display a subset of the parameters based on initial parameter letters.
Example 3a. Display every parameter that can be changed
[Device-Name]>set ?
.
.
.
.
Figure C-5 Result of “set ?” CLI command
Example 3b. Display parameters based on letter sequence
This example shows entries for parameters that start with the letter “i”. The more letters you enter, the fewer the results
returned. Notice that there is no space between the letters and the question mark.
[Device-Name]> show ipa?
Figure C-6 Result of “show ipa?” CLI command
[Device-Name]> show iparp?
Figure C-7 Result of “show iparp?” CLI command
C-5