HP ProCurve 520wl Wireless Access Point - Manual (Page 150)

Command Line Interface (CLI)
[Device-Name]>set snmpv3privpasswd (SNMPv3 privacy password)
[Device-Name]>reboot 0
! CAUTION
We strongly urge you to change the default passwords to restrict access to your network devices to authorized
personnel. If you lose or forget your password settings, you can always perform the
Reset to Factory Default
Procedure .
Set Network Names for the Wireless Interface
[Device-Name]>set wif netname
wireless interface>
[Device-Name]>show wif
Figure C-13 Results of “show wif” CLI command for an AP
C-14