HP ProCurve 520wl Wireless Access Point - Manual (Page 175)

Command Line Interface (CLI)
Syslog Lowest Priority
Logged Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG RW syslogpritolog
Heartbeat Status Integer enable (1)
disable (2) (default) RW sysloghbstatus
Heartbeat Interval (seconds) Integer 1 – 604800 seconds;
900 sec. (default) RW sysloghbinterval
NOTE�
The Heartbeat parameters are advanced settings not available by way of the HTTP interface. When Heartbeat
is enabled, the AP periodically sends a message to the Syslog server to indicate that it is active. The
frequency with which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP. You can configure up to
ten Syslog hosts.
Name Type Values Access CLI Parameter
Syslog Host Table Table N/A R sysloghosttbl
Table Index Integer 1 – 10 N/A index
IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete RW status
Bridge Parameters
Spanning Tree Parameters
Name Type Values Access CLI Parameter
Spanning Tree Group N/A R stp
Spanning Tree Status Integer enable (default)
disable RW stpstatus
Bridge Priority Integer 0 – 65535
32768 (default) RW stppriority
Maximum Age Integer 600 – 4000
(in 0.01 sec intervals;
that is, 6 to 40 seconds)
2000 (default) RW stpmaxage
Hello Time Integer 100 – 1000
(in 0.01 sec intervals;
that is, 1 to 10 seconds)
200 (default) RW stphellotime
Forward Delay Integer 400 – 3000
(in 0.01 sec intervals;
that is, 4 to 30 seconds)
1500 (default) RW stpfwddelay
Spanning Tree Priority and Path Cost Table
Name Type Values Access CLI Parameter
Spanning Tree Table Table N/A R stpbl
Table Index (Port) N/A 1 – 15 R index
C-39