HP ProCurve 520wl Wireless Access Point - Manual (Page 167)

Command Line Interface (CLI)
802.11b Only Parameters
Name Type Values Access CLI Parameter
Distance between APs Integer large (default)
medium
small
minicell
microcell RW distaps
Interference Robustness Integer enable (default)
disable RW interrobust
Operating Frequency Channel Integer 1 - 14; available channels
vary by regulatory
domain/country; see
802.11b Channel
Frequencies
RW channel
Multicast Rate Integer 1 Mbits/sec (1)
2 Mbits/sec (2) (default)
5.5 Mbits/sec (3)
11 Mbits/sec (4) RW multrate
Closed Wireless System Integer enable
disable (default) RW closedsys
Medium Distribution Integer enable (default)
disable RW meddendistrib
MAC Address PhyAddress 12 hex digits R macaddr
Supported Data Rates Octet String 1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec R suppdatarates
Transmit Rate Integer32 0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec RW txrate
Supported Frequency Channels Octet String Depends on Regulatory
Domain R suppchannels
Physical Layer Type Integer dsss (direct sequence
spread spectrum) for
802.11b R phytype
Regulatory Domain List DisplayString U.S./Canada -- FCC
Europe -- ETSI
Japan -- MKK R regdomain
NOTE�
There is an inter-dependent relationship between the Distance between APs and the Multicast Rate. In
general, larger systems operate a lower average transmit rates.
Distance between APs Multicast Rate�
Large
1 and 2 Mbits/sec
Medium 1, 2, and 5.5 Mbits/sec
Small 1, 2, 5.5 and 11 Mbits/sec
Minicell 1, 2, 5.5 and 11 Mbits/sec
Microcell 1, 2, 5.5 and 11 Mbits/sec
C-31