beautypg.com

Maintain client connections using link integrity, Change your wireless interface settings, Command line interface (cli) – HP ProCurve 520wl Wireless Access Point User Manual

Page 154

background image

Command Line Interface (CLI)

Maintain Client Connections using Link Integrity

[Device-Name]>show linkinttbl (this shows the current links)

[Device-Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>

ipaddr

[Device-Name]>set linkintpollint

[Device-Name]>set linkintpollretx

the link down>

[Device-Name]>set linkintstatus enable

[Device-Name]>show linkinttbl (confirm new settings)

[Device-Name]>reboot 0

Change your Wireless Interface Settings

See

Interfaces

for information on the parameters listed below. Dual-radio APs use index 3 for Slot A and index 4 for

Slot B.

Operational Mode

[Device-Name]>set wif mode

mode

Operational Mode

1

dot11b-only

2

dot11g-only

3

dot11bg

4

dot11a-only

5

dot11g-wifi

Autochannel Select (ACS)

ACS is enabled by default. Reboot after disabling or enabling ACS.

[Device-Name]>set wif autochannel

[Device-Name]>reboot 0

Enable/Disable Closed System

[Device-Name]>set wif closedsys

Enable/Disable Interference Robustness (802.11b Only)

[Device-Name]>set wif interrobust

Enable/Disable Load Balancing (802.11b Only)

[Device-Name]>set wif ldbalance

Enable/Disable Medium Density Distribution (802.11b Only)

[Device-Name]>set wif meddendistrib

C-18

See also other documents in the category HP Routers: