Dhcp server parameters, Command line interface (cli), Dhcp server table for ip pools – HP ProCurve 520wl Wireless Access Point User Manual
Page 164: C-28
Command Line Interface (CLI)
DHCP Server Parameters
Name
Type
Values
Access CLI Parameter
DHCP Server
Group
N/A
R
dhcp
DHCP Server Status
Integer
enable (1) (default)
disable (2)
delete (3)
RW
dhcpstatus
Gateway IP Address
IpAddress
User Defined
RW
dhcpgw
Primary DNS IP Address IpAddress
User Defined
RW
dhcppridnsipaddr
Secondary DNS IP
Address
IpAddress
User Defined
RW
dhcpsecdnsipaddr
Number of IP Pool Table
Entries
Integer32
N/A
R
dhcpippooltblent
NOTE�
The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
DHCP Server table for IP pools
Name
Type
Values
Access CLI Parameter
DHCP Server IP Address
Pool Table
Table
N/A
R
dhcpippooltbl
Table Index
Integer
User Defined
N/A
index
Start IP Address
IpAddress
User Defined
RW
startipaddr
End IP Address
IpAddress
User Defined
RW
endipaddr
Width
Integer
User Defined
RW
width
Default Lease Time
(optional)
Integer32
> 0
86400 sec (default)
RW
defleasetm
Maximum Lease Time
(optional)
Integer32
> 0
86400 sec (default)
RW
maxleasetm
Comment (optional)
DisplayString
User Defined
RW
cmt
Status (optional)
Integer
enable (1)
disable (2)
delete (3)
RW
status
NOTE�
Set either End IP Address or Width (but not both) when creating an IP address pool.
C-28