beautypg.com

Alarms parameters, Snmp table host table parameters, Syslog parameters – HP ProCurve 520wl Wireless Access Point User Manual

Page 174: Command line interface (cli), C-38

background image

Command Line Interface (CLI)

Port Number

Octet String

User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137, Index 2:
NetBios Datagram
Service – 138, Index 3:
NetBios Session
Service – 139, Index 4:
SNMP Service – 161)

RW

portnum

Protocol Name

DisplayString

User Defined
(there are also 4
pre-defined protocols,
see

Port Number

above)

RW

protoname

Interface Bitmask

Integer32

0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless A
8 or 10 - Wireless B
12 = Wireless A & B
13 or 15 - all interfaces
(default is 15)

RW

ifbitmask

Status (optional)

Integer

enable (default for new
entries)
disable (default for
pre-defined entries)
delete

RW

status

Alarms Parameters

SNMP Table Host Table Parameters

When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the “comment” argument.

Name

Type

Values

Access CLI Parameter

SNMP Trap Host Table Table

N/A

R

snmptraphosttbl

Table Index

Integer

User Defined

N/A

index

IP Address

IpAddress

User Defined

RW

ipaddr

Password

DisplayString

User Defined (up to 64
characters)

W

passwd

Comment (optional)

DisplayString

User Defined (up to 254
characters)

RW

cmt

Status (optional)

Integer

enable (default)
disable
delete

RW

status

Syslog Parameters

The following parameters configure the Syslog settings.

Name

Type

Values

Access

CLI

Syslog

Group

N/A

R

syslog

Syslog Status

Integer

enable
disable (default)

RW

syslogstatus

Syslog Port

Octet String

514

R

syslogport

C-38