Proxy arp parameters, Ip arp filtering parameters, Broadcast filtering table – HP ProCurve 520wl Wireless Access Point User Manual
Page 173: Tcp/udp port filtering, Command line interface (cli), Tcp/udp port filtering table, C-37
Command Line Interface (CLI)
Proxy ARP Parameters
Name
Type
Values
Access CLI Parameter
Proxy ARP
Group
N/A
R
parp
Status
Integer
enable
disable (default)
RW
parpstatus
IP ARP Filtering Parameters
Name
Type
Values
Access CLI Parameter
IP ARP Filtering
Group
N/A
R
iparp
Status
Integer
enable
disable (default)
RW
iparpfltstatus
IP Address
IpAddress
User Defined
RW
iparpfltipaddr
Subnet Mask
IpAddress
User Defined
RW
iparpfltsubmask
Broadcast Filtering Table
Name
Type
Values
Access CLI Parameter
Broadcast Filtering
Table
Table
N/A
R
broadcastflttbl
Index
Integer
1-5
N/A
index
Protocol Name
DisplayString
N/A
R
protoname
Direction
Integer
ethertowireless
wirelesstoether
both (default)
RW
direction
Status
Integer
enable
disable (default)
RW
status
TCP/UDP Port Filtering
The following parameters are used to enable/disable the Port filter feature.
Name
Type
Values
Access CLI
Port Filtering
Group
N/A
R
portflt
Port Filter Status
Integer
enable (default)
disable
RW
portfltstatus
TCP/UDP Port Filtering Table
The following parameters are used to configure TCP/UDP Port filters.
Name
Type
Values
Access CLI
Port Filtering Table
Table
N/A
R
portflttbl
Table Index
N/A
User Defined
(there are also 4
pre-defined indices, see
Port Number
below for
more information)
R
index
Port Type
Octet String
tcp
udp
tcp/udp
RW
porttype
C-37