Command line interface (cli) – HP ProCurve 520wl Wireless Access Point User Manual
Page 149

Command Line Interface (CLI)
NOTE
We recommend changing your default passwords immediately. To perform this operation using CLI
commands, refer to
Set Basic Configuration Parameters using CLI Commands
There are a few basic configuration parameters that you may want to setup right away when you receive the AP. For
example:
–
Set System Name, Location and Contact Information
–
Set Static IP Address for the AP
–
–
Set Network Names for the Wireless Interface
–
Enable and Configure TX Power Control for the Wireless Interface(s)
–
Set WEP Encryption for the Wireless Interface
–
Download an AP Configuration File from your TFTP Server
–
Backup your AP Configuration File
–
Set System Name, Location and Contact Information
[Device-Name]>set sysname
[Device-Name]>set sysctname
[Device-Name]>set sysctphone
[Device-Name]>show system
Figure C-12 Result of “show system” CLI Command
Set Static IP Address for the AP
NOTE
The IP Subnet Mask of the AP must match your network’s Subnet Mask.
[Device-Name]>set ipaddrtype static
[Device-Name]>set ipaddr
[Device-Name]>set ipsubmask
[Device-Name]>set ipgw
[Device-Name]>show network
Change Passwords
[Device-Name]>passwd
[Device-Name]>set httppasswd
[Device-Name]>set snmprpasswd
[Device-Name]>set snmprwpasswd
[Device-Name]>set snmpv3authpasswd
C-13